Vaisala WMS302 Betriebsanweisung PDF herunterladen (Seite 75)

Chapter 4 _______________________________________________________________ Installation

VAISALA_______________________________________________________________________ 73

1. Connect cables to the connectors on the upper base and tighten the

screw nuts. For connector description, see Table 5 on page 73.

2. Connect the sensor cables to the connectors on the lower base and

tighten the screw nuts. For connector description, see Table 6 on

page 73.

3. Finally, lower the protection cover on the upper base to shield the

connectors.

NOTE

Be careful when connecting cables so that the connector pins will not

bend.

NOTE

After connecting the cables, configure the sensors and auxiliary

devices with the MAWS Lizard Setup software. For more information,

refer to the MAWS Lizard User’s Guide.

Table 5 Default Upper Base Connectors

Connector Sensor/Device

(A) Temp/Humidity QMH101 (HMP45) or WXT510

(B) Wind QMW101 or QMW110 (WMS302)

(D) Rain QMR101 or QMR102

(E) Sol. Rad. QMS101 or QMS102

(F) NET Rad. QMN101

Table 6 Default Lower Base Connectors

Connector Sensor/Device

(H) COM0 Terminal

(I) COM1 Communications or sensors with RS-485 interface

(K) MOD1 Communications or sensors with serial interface

(L) Soil Temp. QMT103 or QMT107

(M) Additional sensor

(O) Additional sensor

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 261 262

Keine Kommentare

Vaisala WMS302 Betriebsanweisung Seite 75