Vaisala WMS302 Betriebsanweisung PDF herunterladen (Seite 128)

User's Guide ______________________________________________________________________

126 __________________________________________________________________M210630EN-B

Setting Static Parameters

To be able to use static parameters in MAWS, you must first create them

in MAWS Lizard and then either use the default values given in MAWS

Lizard or change the values in MAWS Terminal.

The MAWS Lizard Setup Software provides an interface for creating

setup-specific static parameters to be used, for example, as station-

dependent parameters or as calculation factors. This interface is in the

Setup Management view and it is only available on the advanced user

level.

Table 14 Description of MAWS Station Settings Window

Item Description

Station name You can define a name for your station.

Altitude Enter the altitude of the MAWS station from sea level.

Pressure sensor

level

The height of the pressure sensor on the MAWS mast.

Capacity of the

internal battery

Enter the capacity of the MAWS internal battery

QMB101. Note that this value is set to zero when high

capacity back-up batteries are included in the delivery,

which normally is the case with the HydroMet systems.

MAWS time and

date

After you change the MAWS battery, you need to set the

system clock. Type the correct time (HH:MM) and date

(YY-MM-DD) in the appropriate fields and click Save.

Static Parameters

tab

The list of the static parameters (depends on your

configuration).

Sensor

Calibration tab

The list of the connected sensors and the calibration

values (depends on your configuration).

Manual Entry tab The list of the manual sensors and their values is visible

only when manual sensors are included in the setup

(depends on your configuration).

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 261 262

Keine Kommentare

Vaisala WMS302 Betriebsanweisung Seite 128