Vaisala WMS302 Betriebsanweisung PDF herunterladen (Seite 195)

Chapter 7 ___________________________________________________________ Troubleshooting

VAISALA______________________________________________________________________ 193

1. For any sensor enter the following service terminal command:

LASTVAL <measurement_name> status

For example:

/ > LASTVAL TAMeasQMH101_1 status Status:1 Value:0

For details on the LASTVAL command, refer to section

LASTVAL Command on page 198.

2. For conventional sensors, open the Sensor Calibration tab in

MAWS Terminal, see Figure 116 on page 129. The list of the

MAWS sensors is displayed in the tab. The Status column shows

the sensor status. To read the latest sensor statuses and

measurement values, click the Refresh button. Table 15 on page

130 describes the other columns in the Sensor Calibration tab.

0312-038

Figure 149 MAWS Station Settings Window: Sensor Calibration

Tab

where

Status:1 = The Status field in the output is the value status.

Valu e: 0 = Th e Value field shows the sensor status value.

CAUTION

When you upgrade a previous MAWS version to 3.06 or above, the

following sensors will not operate correctly in the Sensor Calibration

tab until they are removed from the setup and then re-created: CM6B,

CM11, QMS101, QMS102, and QMN101.

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 261 262

Keine Kommentare

Vaisala WMS302 Betriebsanweisung Seite 195