Vaisala WMS302 Betriebsanweisung PDF herunterladen (Seite 158)

User's Guide ______________________________________________________________________

156 __________________________________________________________________M210630EN-B

Command Reference for Terminal Connection

Table 20 Command Set

Command Description

altitude altitude [meters]. To see the current station altitude, type altitude. To

change the altitude, type altitude and the new station altitude in meters

from sea level.

battery battery [capacity] sets the capacity of the internal battery, needed for MAWS

internal control. Accepted capacity values are 1.2 ... 24 Ah. To see the

battery status, type battery. Note that the battery command applies only to

the internal battery.

cd cd [directory path] changes the current directory. cd / gets you back to the

root directory. NOTE! cd .. Cannot be used.

chmod chmod <filename> <r/w/x> changes the file access attributes: read (r), write

(w) or execute (x). The setup file "Basic/Advanced/Lowpower" needs to

have attributes rwx.

close Closes terminal connection.

copy copy <source file> <destination file> copies a file to another location.

del del <filename> deletes a specified file. Only files that have (w)rite access

attribute can be deleted (see command chmod).

dir dir [file/path] displays a list of a directory's files and subdirectories, used and

free disk space. The file information includes name, access_attributes, time,

date and size.

disable disable [Measurement Name] disables the measurement input or sensor.

enable enable [Measurement Name] enables the measurement input or sensor.

errors errors [clear]. To see active errors, type errors. To clear active errors, type

errors clear. Errors indicate that there is something wrong in the software.

EXTFS EXTFS <INFO|ERASE>. To format Compact Flash card, type EXTFS

ERASE. To show card info, type EXTFS INFO. NOTE! The command must

be written in upper case.

help help [command] displays a command syntax. To list all the available

commands, type help.

LASTVAL LASTVAL [Measurement] [raw | Signal name] shows the measured value

before any validation and the status produced during validation. The

validated value is shown when you give the signal name that is defined in

MAWS Lizard.

logdel logdel <log_group_id> <lastdate (dYYMMDD)> deletes a log file/files dated

earlier than the last given date.

LOGFS LOGFS <ERASE> erases all data in the log system and resets MAWS.

NOTE! The command must be written in upper case.

loggo loggo <log_group_id> starts logging of the defined log group.

logshow logshow <log_group_id> [start (YYMMDDHH)] [count] [item numbers]

logshow L1shows one line of current day; logshow L1 40 shows 40 lines;

logshow L1 40 3 shows 40 lines of item 3; logshow L1 030618 10 shows

10 lines starting from 18.06.2003

logshownext logshownext <log_group_id> [count]. After the logshow command, can be

used to show the immediately following (later) log entries.

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 261 262

Vaisala WMS302 Betriebsanweisung Seite 158

Kommentare zu diesen Handbüchern

Vaisala WMS302 Betriebsanweisung Seite 158

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Messen, Testen & Steuern Vaisala WMS302