
Chapter 4 _______________________________________________________________ Installation
VAISALA_______________________________________________________________________ 69
6. Tighten part 3 to connect it with part 4, see Figure 54 on page 69.
Insert the sealing part 2 into part 1. Tighten part 1 to part 3.
0312-007
Figure 54 Solar Panel Connector Assembly
7. Attach the plug to the Solar connector by tightening the lowest nut.
8. Adjust the angle of the solar panel.
Installing a QMP Power Supply
Optionally MAWS can be powered from a QMP power supply.
Mains Power Supply QMP213
Mains Power Supply QMP213 is delivered with the U-bolts, washers,
nuts, and the connector cable for MAWS. The unit is attached to the
mast.
It is mountable to a Ø 60 mm or 100 mm pole mast as well as to one of
the tripod legs of the MAWS201 weather station.
NOTE
In the figures only the metallic connector is presented, although the
procedure is the same with the plastic connectors.
Kommentare zu diesen Handbüchern