Vaisala WMS302 Betriebsanweisung PDF herunterladen (Seite 69)

Chapter 4 _______________________________________________________________ Installation

VAISALA_______________________________________________________________________ 67

1. Locate the leg where the solar panel is to be installed. The correct

leg is the one having DC Power Input label on the left side. Also

note the alignment of sensor arms versus solar panel.

2. Place the solar panel towards the leg approximately 40 cm (1.3 ft.)

down from the upper plate of the tripod. Make sure that the shelf

(number 1 in Figure 49 on page 67) fits to the leg profile (2). When

the panel is at suitable height, tighten the hand screw (3).

0406-049

Figure 49 Solar Panel Fixture

3. Open the bolt (number 3 in Figure 50 on page 67) of the leg

fastener (1) to release the leg (2). Fit the cable inside the leg and

guide it through the hole in the leg fastener. Put the leg back into

the leg fastener and tighten the bolt (3). Attach the cable to the DC

Power Input connector.

0201-027

Figure 50 Tripod's Leg Attachment

4. Thread the cable through the connector parts in the indicated order

1-2-3-4. Parts for a metallic connector are shown in Figure 51 on

page 68. Parts for a plastic connector are shown in Figure 52 on

page 68.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 261 262

Keine Kommentare

Vaisala WMS302 Betriebsanweisung Seite 69