Vaisala PTB210 SERIES Bedienerhandbuch PDF herunterladen (Seite 110)

BGC-FTIR Sensors | PTB 210 25

Operation

The PTB210 can be operated through a serial line with any terminal emulator

program and the commands given in the following pages. Note to use the right

parameters for communication with the RS232-Port on your PC or laptop.

(baud rate 9600, parity even, data bits 7, stop bits 1)

General and Communication

The general command format is:

.ZZZ.xxx<cr>

• ZZZ = event

• xxx = given value of a parameter

If there are several barometers on same line, it is necessary to use an ID-code:

123.ZZZ.xxx<cr>

The default ID-code is 0. If necessary, you can change the ID:

.ID.xxx<cr>

• xxx = identiﬁcation code (max. 15 characters)

To set the baud rate of the barometer use the command:

.BAUD.xxxx<cr>

• xxxx = baud rate (1200...19200

NOTE: The barometer does not echo the given commands nor conﬁrm the

new settings by echoing them. However, the settings can be checked

with the command ?<cr>. Make sure to reset the barometer with

the command .RESET<cr> to activate the new settings.

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 136 137

Keine Kommentare

Vaisala PTB210 SERIES Bedienerhandbuch Seite 110