Vaisala DRYCAP DMT345 Betriebsanweisung PDF herunterladen (Seite 41)

Chapter 3 _______________________________________________________________ Installation

VAISALA _______________________________________________________________________ 41

6. Mount lower part (item 5) on the housing.

7. Push the seal with the contact socket of the gland (item 2 & 3) and

flush into the lower part (item 5).

8. Install the domed cap nut (item 1) onto the lower part (item 5).

Transmitter Housing Grounding

In case you need to ground the transmitter housing, the grounding

connector is found inside the housing (see Figure 1 on page 22). Note

anyhow that the probe is connected to the same potential as the housing.

Make sure that different groundings are made to the same potential.

Otherwise harmful ground currents may be generated.

If it is needed to have galvanic isolation of the power supply line from

the output signals, DMT346 can be ordered with optional output isolation

module. This module prevents harmful grounding loops.

Signal and Power Supply Wiring

When connecting transmitter with 8-pin connector, see section 8-Pin

Connector on page 60.

0605-028

Figure 26 Screw Terminal Block on the Motherboard

Numbers refer to Figure 26 above:

1 = Supply terminals POWER 10 ... 35 VDC = 24 V~

2 = User port (RS-232 terminals)

3 = Analog signal terminals

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 156 157

Keine Kommentare

Vaisala DRYCAP DMT345 Betriebsanweisung Seite 41