Vaisala HUMICAP MMT162 Betriebsanweisung PDF herunterladen (Seite 40)

User's Guide _______________________________________________________________________

38 ___________________________________________________________________ M210934EN-D

Stop Measurement Output

Use the S command to end the RUN mode. After this command all other

commands can be used. You can also press the Esc button or reset the

transmitter to stop the outputting.

S<cr>

Since the interface is half-duplex, you must enter the command when the

transmitter is not outputting. Give the command again if the transmitter

continues to output measurement messages.

See SMODE command on page 33 to change the default (power-up)

operation mode.

Set Output Interval

Use the INTV command to set or display the output interval.

INTV [n xxx]<cr>

where

time interval = 0 ... 255

xxx

time unit = "S", "MIN", or "H"

Example:

intv 1 min

Output interval: 1 MIN

The shortest output interval (with n = 0) is approximately one second due

to the internal measurement cycle.

Output Reading Once

Use the SEND command to output the reading once in STOP mode.

The output format depends on which parameters the transmitter can

output.

SEND [aaa]<cr>

where

aaa

Transmitter address (0 ... 255). Must be specified if the

transmitter is in POLL mode, and a line has not been opened

using the OPEN command.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 74 75

Keine Kommentare

Vaisala HUMICAP MMT162 Betriebsanweisung Seite 40