Vaisala HMP243 Betriebsanweisung PDF herunterladen (Seite 98)

HMP240

Appendix 2: RS 485/422 serial port module M210300en

• Set the address of the transmitter; you can choose any number

between 1 and 99. In this example the address is 22:

>addr 22

Address : 22

• Set the serial bus settings according to your network specifications.

This setting will become valid after next RESET or power off:

>seri 2400 e 7 1 h

2400 E 7 1 HDX

• Set the transmitter in POLL mode:

>smode poll

Serial mode : POLL

NOTE 1

The SMODE command must be given last.

NOTE 2

The transmitter outputs no prompt (>) after the SMODE

POLL command and it only reacts to commands which

include its address.

• Check that the transmitter responds to its address:

>send 22

RH= 24.4 %RH T= 29.1 'C

• Disconnect the terminal.

• Check that the jumpers in connector X4 are in the right places.

X1 X2

• Remount the RS 485/422 serial module.

• Close the cover.

• When all transmitters on the network have been configured, switch

them off.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 129 130

Keine Kommentare

Vaisala HMP243 Betriebsanweisung Seite 98