User's Guide _______________________________________________________________________
92 ___________________________________________________________________ M210764EN-F
List of Serial Commands
All commands can be issued either in uppercase or lowercase. In the
command examples, the keyboard input by the user is in bold type.
The notation <cr> refers to pressing the carriage return (Enter) key on
your computer keyboard. Enter a <cr> to clear the command buffer
before starting to enter commands.
In the tables below, the bold text in the brackets is the default setting.
Table 17 Measurement Commands
Start the continuous outputting
Stop the continuous outputting
Set the continuous output interval
(for RUN mode)
Output the reading once from all connected
transmitters (in STOP or POLL mode)
[STOP/SEND/RUN/POLL/
Set the serial interface mode
View or set user port (RS232 or RS485) answer
minimum delay
User Port settings (Default: 4800 E 7 1) baud:
300 ... 115200
Set the transmitter address (for POLL and
MODBUS modes)
View or set networking parameters for LAN and
WLAN interfaces
View or set wireless network parameters for
WLAN interface
Open a temporary connection to a POLL mode
device
Close the temporary connection (Back to POLL
mode)
Table 18 Formatting Commands
Set the output format of SEND and R
commands
Add time to SEND and R outputs
Add date to SEND and R outputs
Assign a new command name that works like
the SEND command
Select the metric or non-metric output units
Kommentare zu diesen Handbüchern